Volume Pre-Selection Of Sound Signal; Song Selection - End Of Run - Hermle Z 327 K User Manual

PRODUCT DESCRIPTION
Figure 8

1.8.4 Volume Pre-Selection of Sound Signal

Proceed as illustrated, under point 1.8.1, to enter this program mode, press the key "accel/decel" (5). In the
display, "accel/decel" (A-2), flashes the word, "service". Select the letter, "U" with the control field (1). As a result,
appearing in the display, "rpm/rcf" (A-1), are the words, "Vol=0- 9/Sound". By pressing the key, "rpm/rcf" (4), the
desired volume can be adjusted between 0 (low) and 9 (loud), with the control field (1), (see Figure 9
).
After the settings have been stored by user, the normal program mode can be changed back again
by switching off the centrifuge, for a short period.
Figure 9

1.8.5 Song Selection - End of Run

Proceed as illustrated, under point 1.8.1, to enter this program mode, press the key, "accel/decel"
(5). In the display, "accel/decel" (A-2) flashes the word, "service". Select the letter, "G" with the
control field (1). As a result, appearing in the display, "rpm/rcf" (A-1), the word " SonGo/Sound". After
pressing the key „rpm/rcf" (4), select a song with the control field (1), (see Figure 10).
After the settings have been stored by user, the normal program mode can be changed back again
by switching off the centrifuge, for a short period.
10
Z327K_V1.22_eng
9
8
© Hermle Labortechnik GmbH