Radius Correction; Program; Storage Of Programs - Hermle Z 327 K User Manual

Table of Contents

2.4 Radius Correction

If adapters or reducers are being used, it could change the centrifugal radius of the respective rotor.

In that case, the radius can be corrected manually.

Please proceed as follows:

First close the centrifuge lid and press afterwards the key "time" (6) and the key "prog" (11) at the

same time and hold down.

In the display, "time" (A-3), appears the word "radius" (M9). With the control field (1), pre-select the

respective radius correction, (see "Table 8: Radius Correction", APPENDIX P. IX), in steps of 0.1cm.

As soon as the radius correction is set, the word "radius" (M9) appears. This text remains visible

until the radius correction is set back to 0.

For all number marked text, please refer Figure 28.

Figure 28

The program stores up to 99 runs, with all relevant parameters, including the used rotors. Any free

program number is available and can be retrieved.

Put the desired rotor into the centrifuge. By pressing the key, "prog" (11), in the display "time" (A-3)

appears the word "program", (see Figure 29). With the control field (1), choose the desired program

number.

If a program number is already occupied, in the display "rpm/rcf" (A-1), the words "rotor" (M3) and

"22x.xx" (M4) will appear, (see Figure 29). Free program numbers will appear as 0.

Figure 29

Z327K_V1.22_eng

OPERATION

Table of Contents