Table of Contents
Advertisement
34
6.6. Main menu, Power limit
The device calculates the expected average performance
(15 min) from actual power. If this value is greater than the
setting limit, the device set to active state the digital1
output.
If the value is lower than the limit at the next sampling, the
device turn back the digital1 output. If the value is greater
than the setting limit, the device holds the digital1 output to
active state, and the digital2 output sets to active state. At
the next sampling the value of expeted average power is
lower the settings limit, the device set the digital2 output to
inactive state.
These outputs states are repeated within a 15 minute
period.
You can setting this function on 7.2. Modul #1 settings and
7.4. Power limiting of 7. Configurations menu.
P maximum: Adjustet demand limit (The value is equal
1.Tariff / 2.Tariff / 3.Tariff / 4.).
P expected: Expected power demand value for end of 15.
minutes
P current: Current power demand value
Elapsed Time: time after the last sync pulse
PQRM5300 33 Ux Ix xx xx (PS)
20201120-V1
Advertisement
Table of Contents
