Dismounting; Dismounting Procedure - Datcon PQRM5300 33 U I Series Instruction Manual

Three-phase power meter

Table of Contents

Dismounting from the

rail

9. Dismounting

Before dismounting take note the warnings written in

Chapter 5.1.

The following figure shows the dismounting procedures:

The dismounting procedure needs a screwdriver for slotted

screws.

1. Switch off the power supply of the instrument.

2. Remove all cable.

3. Loosen the fixing screw (anticlockwise) according the

figure. Step (1).

4. Push the end of the mouting clamp screw forward, and

then rotate it downward to release it from the rear retaining

rivet. Step (2)..

5. Remove the mounting clamp from the front rivet

according the figure Step (3).

6. Do the above procedure with the other mounting clamp

also (Step (1) - Step (4)).

7. Pull out the instrument from the panel.

PQRM5300 33 Ux Ix xx xx (PS)

20201120-V1

Table of Contents