Menu Item 10 And 11: Setting Limit Outputs - Datcon DT4220 E Series Operating Instructions Manual

DT4220 E
Function
Sequence of operations Read the chapter 7.1. Functions of the push-buttons during
20180619-V0

7.13. Menu item 10 and 11: Setting limit outputs

The instrument has two optional limit outputs. They are identical with
each other, and work independently.
Operation: the instrument keeps comparing the displayed physical
value with the (adjustable) limit value. It switches the output ON or
output OFF depending whether the displayed value is higher or lower
than the limit value.
navigation in the menu for learning the buttons handle.
1. Enter the menu by typing the supervisor code.
2. Keep stepping by pressing the ▲ button as long as you see this
menu item.
3. Enter the menu item by pressing the Menu button.
4. Pressing the ▲ button, select the desired sub-menu item.
5. You can enter to sub-menu by pressing the Menu button and you
can exit from sub-menu item by pressing the Esc button.
(6. Press Esc button again if you want to leave the menu.)
The selectable sub-menus:
 limit 1: Setting the operating mode
 limit 1: Low limit value
 limit 1: Hysteresis of the limit output
 limit 1: High limit value
 limit 1: Limit output hold mode
39