Table of Contents
Advertisement
Mounting with the
mounting clamps
14
Before fitting the instrument into the panel cut-out it is
recommended to exercise the using of mounting clamps.
Put the instrument onto a table and follow the steps (from
step 2.) written under the figure:
Please do not exercise forces higher than necessary, as it
may cause damages to the clamp.
1. Pulsh in the instrument to the panel.
2. Insert the mounting clamp into the front rivet.
(according the figure Step (2))
3. Rotate the mounting clamp in the direction of the arrow
until it snaps into the groove in the rear mounting rivet.
(according the figure Step (3)
4. Screwing the fixing screw (clockwise) according the figure
Step (4).
5. Do the above procedure with the other mounting clamp
also (Step (1) - Step (4)).
Check the hold of the instrument in the panel cut-out by
moving on it firmly.
PQRM5300 33 Ux Ix xx xx (PS)
20201120-V1
Advertisement
Table of Contents
