Datcon PQRM5300 33 U I Series Instruction Manual page 55

PQRM5300 33 Ux Ix xx xx (PS)
20201120-V1
"Signal outside limit"
The output changes into active state when measured value
is out upper and lower limit as the monitored value. The
output changes into inactive state when measured value is
between of range upper and lower limit as the monitored
value. The hysteresis is like the high and low limit functions
can use it.
10. Press the SEL switch.
11. Press the OK switch.
12. Type the High limit value with help  , - , +
switches, and press the OK switch to accept the value
13. Type the Low limit value with help  , - , + switches,
and press the OK switch to accept the value.
14. Type the High limit value with help  , - , +
switches, and press the OK switch to accept the value
15. Select from the menu with  switch the output
polarity.
When you select the "NO (Normally open)" state then the
output transistor is in off state when there is no pulse on the
output. When you select the "NC (Normally closed" state
then the output transistor is in on state when there is no
pulse on the output.
16. Press the SEL switch.
17. Press the OK switch.
18. Press the BACK switch to exit from Modul #1 settings
submenu
55