Table of Contents
Advertisement
5 OPERATION
5
OPERATION
General safety regulations for handling the equipment can be found in the "SAFETY" chapter
of this manual. Read it through before you start using the equipment!
WARNING!
To avoid shock, do not touch the electrode wire or parts in contact with it, or uninsulated cable
or connections.
NOTE!
When moving the equipment, use the handle intended for transportation. Never pull the
equipment by the welding torch.
WARNING!
Wire feeders are intended to be used with power sources in GMAW and SMAW mode. If used
in GMAW, the SMAW holder must be disconnected from the wire feeder and the OKC must be
covered. If used in SMAW, the GMAW torch becomes energized, the torch must be kept in the
torch holder (if available) or disconnected.
WARNING!
Make sure the side panels are closed during operation.
WARNING!
To prevent the reel from sliding off the brake hub, lock the reel in place by tightening the brake
hub nut.
NOTE!
Replace the brake hub nut and the brake hub sleeve if they are worn out and don't lock
properly.
0463 786 001
- 16 -
© ESAB AB 2023
Advertisement
Table of Contents
