Internal Control Panel; Buttons - ESAB ROBUSTFEED EDGE Instruction Manual

6 CONTROL PANEL
6.2

Internal control panel

1. Function buttons
2. Back button
3. Push encoder knob
4. Menu button
6.2.1

Buttons

Function button (1)
These buttons are used according to the functions shown on the left side panel of the display (7).
Back button (2)
Press the back button once to navigate to the previous step.
Push encoder knob (3)
Rotate the knob to navigate in the menus and press the push encoder to select/change the parameter.
Gas purge button (5)
Gas purging is used while measuring the gas flow or for flushing any air or moisture from the gas
hoses before welding starts. Gas purging occurs for 20 seconds when the gas purge button or torch
trigger is pressed or until it is pressed again. Gas purge occurs without voltage or wire feed start.
Wire inch button (6)
Wire inching is used to feed wire without welding voltage being applied. The wire is fed as long as the
button is pressed.
0463 786 001
5. Gas purge button
6. Wire inch button
7. Display
- 34 - © ESAB AB 2023