Attaching The Wheel Kit; 5.14.1 Attaching The Wheels To The Wheel Kit Frame; 5.14.2 Wire Feed Unit In Vertical Position - ESAB ROBUSTFEED EDGE Instruction Manual

5 OPERATION
5.14

Attaching the wheel kit

5.14.1 Attaching the wheels to the wheel kit frame

Before the wire feed unit is attached to the wheel kit, fasten the wheels to the frame by means of the
M12 screws, washers and nuts, using a tightening torque of 40 ±4 Nm (354 ±35.4 in. lb). The fixed
wheels at the rear end should be positioned parallel to the frame.

5.14.2 Wire feed unit in vertical position

0463 786 001 - 25 - © ESAB AB 2023