JDS Uniphase Wavetek DSAM-3500B Quick Start Manual page 67

Field meter
Table of Contents

Advertisement

Chapter 2 DSAM Meter Operation
DSAM Firmware Upgrade Instructions
Ensure that the DSAM(s) you are upgrading appear in the
Meter Assets list, specified by serial number. If they are
not on the list, you must add the DSAM(s) and synchronize
them before you proceed to the next step.
In the "meter management tasks" sidebar on the left of the
manage meter assets page, click on "upgrade meters".
On the upgrade meters page, click "browse" in step one
and select the downloaded .xml file from the location you
saved it to, in step 5 of this list. Then click "open".
The list of meter(s) that can be upgraded should now be
displayed on this page. If there is no list, please review the
previous steps or contact Technical Assistance Center
(TAC) at the number below for further assistance. Ensure
that only the meter(s) that you wish to upgrade are
checked. De-select those meters you do not wish to
upgrade.
Click the "done" button in the bottom right corner.
Synchronize the DSAM(s) with FDM or TPP.
After the meter has rebooted, verify the upgrade is
successful. Check the "manage meter assets" page, sync
"Status" column, and ensure the most recent sync is OK,
and check the "FW Version" to see that it matches the
latest version you deployed (eg. v3.5).
If the meter reboots to a screen that says "Upgrade was
not completed, press soft key 1 to retry the upgrade" you
should repeat steps 9 and 10 and re-deploy the upgrade
BEFORE pressing the key to re-synchronize.
Congratulations! The latest DSAM firmware has now been
installed!
DSAM Product Family Quick-Start Guide Rev. 001
51

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Wavetek DSAM-3500B and is the answer not in the manual?

Table of Contents