Maximum Value; Diameter; Intermediate Height - Endress+Hauser Levelflex FMP50 PROFIBUS PA Operating Instructions Manual

Levelflex FMP50 PROFIBUS PA

Maximum value

Navigation
Prerequisite
User entry
Factory setting

Diameter

Navigation
Prerequisite
User entry
Factory setting
Additional information

Intermediate height

Navigation
Prerequisite
User entry
Factory setting
Endress+Hauser
 Setup → Advanced setup → Linearization → Maximum value
Linearization type (→  142) has one of the following values:
• Linear
• Pyramid bottom
• Conical bottom
• Angled bottom
• Horizontal cylinder
• Sphere
–50 000.0 to 50 000.0 %
100.0 %
 Setup → Advanced setup → Linearization → Diameter
Linearization type (→  142) has one of the following values:
• Horizontal cylinder
• Sphere
0 to 9 999.999 m
2 m
The unit is defined in the Distance unit parameter (→  121).
 Setup → Advanced setup → Linearization → Intermediate height
Linearization type (→  142) has one of the following values:
• Pyramid bottom
• Conical bottom
• Angled bottom
0 to 200 m
0 m
Operating menu



145