Backlight; Contrast Display - Endress+Hauser Levelflex FMP50 PROFIBUS PA Operating Instructions Manual

Operating menu
Selection
Factory setting
Additional information

Backlight

Navigation
Prerequisite
Description
Selection
Factory setting
Additional information

Contrast display

Navigation
Description
User entry
Factory setting
Additional information
168
• x
• x.x
• x.xx
• x.xxx
• x.xxxx
x.xxxx
• Is only valid for numbers in the operating menu (e.g. Empty calibration, Full
calibration), but not for the measured value display. The number of decimal places for
the measured value display is defined in the Decimal places 1 to 4 →  165
parameters.
• The setting does not affect the accuracy of the measurement or the calculations.
 Setup → Advanced setup → Display → Backlight
The device has the SD03 local display (with optical keys).
Switch the local display backlight on and off.
• Disable
• Enable
Disable
Meaning of the options
• Disable
Switches the backlight off.
• Enable
Switches the backlight on.
Regardless of the setting in this parameter the backlight may be automatically
switched off by the device if the supply voltage is too low.
 Setup → Advanced setup → Display → Contrast display
Adjust local display contrast setting to ambient conditions (e.g. lighting or reading angle).
20 to 80 %
Dependent on the display.
Setting the contrast via push-buttons:
• Darker: press the
• Brighter: press the
buttons simultaneously.
E
buttons simultaneously.
E
Levelflex FMP50 PROFIBUS PA
Endress+Hauser