Table of Contents
Advertisement
Installation
6.8
Armstops
Fit end stops between the 1st booms and the rear
beam of the vehicle floor. The left and right end stops
must be reached at the same time, as high up the
1st boom as possible. Installation must take place
against the vehicle body.
WARNING!
It is not permitted to perform welding on the lift
arm. Installation must take place against the
vehicle body.
6.9
Sealing strip (horizontal)
The track is fitted using the self-tapping screws
provided.
1. Mark where to drill holes for the self-tapping
screw.
2. Drill holes (Ø 7.2 mm) for the screws.
3. Fit the horizontal stop strip (steel or aluminium).
4. Fit the rubber strip in the track.
6.10
Sealing strip (vertical)
1. Fit the tracks with countersunk screws, rivets or
by spot welding.
2. Fit the rubber strip in the track.
3. Secure the rubber strips by swaging the tracks
together at the bottom.
NOTE.
To fit an upper edge seal, create a 45° mitre
against the vertical strips.
28
Image 40. Fit end stops between the 1st booms
and the rear beam of the vehicle floor
Image 41. Installing a sealing strip
Z 10/15/20
www.zepro.com
Hide quick links:
Advertisement
Table of Contents
