Operation; Transportation - ESAB Versotrac Cadet EWT 1000 Instruction Manual

5 OPERATION
5

OPERATION

CAUTION!
Read and understand the instruction manual before installing or
operating.
General safety regulations for handling the equipment can be found in the "SAFETY" chapter
of this manual. Read it through before you start using the equipment!
NOTE!
When moving the equipment use intended handle. Never pull the cables.
NOTE!
The tractor is supplied with a strap. It can be used to collect the welding cables behind the
tractor.
5.1

Transportation

It is possible to transport the Versotrac Cadet EWT 1000 Welding tractor by following the
instructions in section "Lifting instructions".
NOTE!
Make sure the welding head has cooled down before transportation.
1) Turn off and disconnect the power source. Disconnect the cables to the welding head and the
tractor carriage (1). Remove the cables from the welding tractor.
NOTE!
If the power source is disconnected without turning off power first, the power source
emergency stop can be activated.
2) Remove wire from wire feed unit and wire liner (2).
0463 893 001 - 16 - © ESAB AB 2023