High Temperature; High Inductance; Lost Contact With The Unit; Speed Error On A Motor (Wire Feed, Travel Motor) - ESAB Versotrac Cadet EWT 1000 Instruction Manual

8 EVENT CODES

4203 High temperature

The power source has overheated. Welding is cancelled. Welding is permitted again when the
temperature falls below the maximum temperature parameter.
1. Check that the cooling air inlets or outlets are not obstructed or clogged with dirt.
2. Check the duty cycle being used, to make sure that the equipment is not being overloaded.

5010 High inductance

Inductance is too high, depending on long welding cables and/or high weld data.
1. Adjust the welding data.

8117 Lost contact with the unit

Lost contact with a unit.
1. Check wiring and the connector between the control unit and power source.

Speed error on a motor (wire feed, travel motor)

8411
sub-
code
0
A motor cannot maintain its speed. Welding stops.
1. Check that the wire feed has not jammed or runs too fast. If the error persists, send for a service
technician.
2. If the error persists, send for a service technician.

A motor has stopped

8411
sub-
code
1
There are no pulses from the motor pulse transducer.
For LAF and TAF: 168 = Motor M1 (Wire feeder motor), 169 = Motor M2 (Travel motor).
1. Check the motor cables. Replace the pulse transducer.
0463 893 001 - 38 - © ESAB AB 2023