Event Codes; High Dc Voltage; High Temperature; Low Welding Current - ESAB Versotrac Cadet EWT 1000 Instruction Manual

8 EVENT CODES
8

EVENT CODES

Error management codes are used to indicate that an error has occurred in the welding process. It is
indicated in the display via a pop-up menu.
This manual describes the error codes for Versotrac Cadet EWT 1000. The error codes for other units
are described in the manuals for these units.
For Error codes of the Versotrac Cadet Control unit, see separate instruction manual.

High DC voltage

4
1. Check if the main voltage is too low or too high.

High temperature

6
The power source has overheated. Welding is cancelled. Welding is permitted again when the
temperature falls below the maximum temperature parameter.
1. Check that the cooling air inlets or outlets are not obstructed or clogged with dirt.
2. Check the duty cycle being used, to make sure that the equipment is not being overloaded.

Low welding current

7
The weld arc has been shut down due to too low welding current during the welding process.
1. Is reset at next weld start. If the error persists, send for a service technician.

Low battery voltage

8
Battery voltage too low. If the battery is not replaced, all stored data will be lost. This error does not
disable any functions.
1. Send for a service technician to replace the battery.

Speed error on a motor (wire feed, travel motor)

11
A motor cannot maintain its speed. Welding stops.
1. Check that the wire feed has not jammed or runs too fast. If the error persists, send for a service
technician.
2. If the error persists, send for a service technician.

Internal communication error (warning)

12
The load on the system's CAN-bus is temporarily too high. The power source may have lost contact
with the control unit
1. Check that all the equipment is correctly connected. If the error persists, send for a service
technician.
0463 893 001 - 35 - © ESAB AB 2023