Table of Contents
Advertisement
4 INSTALLATION
3
TECHNICAL DATA
Capacity
Voltage
Frequency
Output
Temperature
Outer dimensions (L*W*H, cm)
Weight (Without electrodes)
NOTE!
Oven heating temperature can be set from surrounding ambient to 400 °C.
4
INSTALLATION
NOTE!
Make sure that the technical specification on the product corresponds to the electrical supply
in your network.
Check the voltage, frequency information and check that there is no fault that will affect the
operation of the product.
4.1
Operation
WARNING!
When the oven is not in use, turn the power knob to "O" position and remove power cord plug
from electrical outlet.
•
Connect oven power cord plug to a power outlet as recommended in the technical
information. Make sure the power outlet socket matches the oven power plug type.
•
Lock the door after the required amount of flux loaded (up to 50 kg).
•
Lock the door.
•
On the oven control panel, to turn on the oven change power knob to "I" position.
•
Once the power is turned on, depending upon the type of your oven i.e 1Φ one green
lamp will glow or 3Φ three green pilot lamps will glow. If the lamps or not glowing,
then check the power connection. Refer the below image.
0448 023 001
50 kg (110 lbs.)
3 phase 380-415 V
Up to 400 °C (752 °F) Digital thermostat
107 × 67 × 113
110 kg (242 lbs.)
- 5 -
SDF-50
50/60 Hz
3000 W
© ESAB AB 2023
Advertisement
Table of Contents
