Welding Menu - ESAB Versotrac Cadet EWT 1000 Instruction Manual

5 OPERATION
The SET screen is used to change welding settings and save settings to the memory slots using the
keys 1, 2 and 3.
Turn any of the knobs during welding to open the
values are shown during 2 seconds before returning to the
adjustments are made.
If the SET screen is opened without ongoing welding, it will stay active. When welding starts, the
MEASURED screen is activated.
Change the welding settings by using the knob next to the value shown on the display. It it possible
to save the settings for easy access.
A short press on any of the keys 1, 2 or 3 will display the saved welding data memory
settings, set the values and show the the
memory number in use is shown on the
the corresponding number.
With AC power source: A short press on the OK button opens the
A long press on the OK button opens the
button.
5.7.6

Welding menu

When any of the screens
extended WELDING
The information on the display depends on the authorisation level, attached power source and
welding head. The authorisation level is shown with an icon in the upper right corner of the display.
Example of welding menu for Aristo® 1000 AC/DC
WELDING MENU
METHOD
REGULATION TYPE
START TYPE
CRATER FILL TIME
BURNBACK TIME
Example of welding menu for SAW welding with LAF or TAF
WELDING MENU
REGULATION TYPE
START TYPE
CRATER FILL TIME
BURNBACK TIME
0463 893 001
SET screen from the
MEASURED
SET
WELDING
SET or MEASURED
MENU.
DC+
CA
DIRECT
O.O s
0.50 s
CA
DIRECT
O.O s
0.7 s
- 25 -
MEASURED
MEASURED screen unless any
screen again. The welding data
tab and also with a bar above the key with
AC SETTINGS
MENU. Return by pressing the Back
is shown, press long on OK to open the
screen. The
screen.
© ESAB AB 2023