Changing The Feed Roller; Refilling With Flux Powder; Upgrading The Tractor To 4 Wheel Drive - ESAB Versotrac Cadet EWT 1000 Instruction Manual

5 OPERATION
5.4

Changing the feed roller

1. Release the knob (3).
2. Release the hand wheel (2).
3. Change the feed roller (1).
The feed rollers are marked with their respective wire
sizes.
5.5

Refilling with flux powder

1. Close the flux valve (1) on the flux hopper.
2. Remove the optional cyclone on the flux recovery unit,
if fitted.
3. Fill with flux powder.
NOTE!
The flux powder must be dry. Use preheated
flux powder only when the flux hopper is
designed for that.
4. Position the flux tube without twisting it.
5. Adjust the height of the flux nozzle above the weld so
that the correct amount of flux is delivered.
Flux coverage should be sufficient so that penetration
of the arc does not occur.
5.6

Upgrading the tractor to 4 wheel drive

NOTE!
The following pictures can differ from the Cadet version of the tractor. The pictures are
however correct when it comes to handling the equipment.
0463 893 001 - 19 - © ESAB AB 2023