Keys And Knobs - ESAB Versotrac Cadet EWT 1000 Instruction Manual

5 OPERATION
5.7.1

Keys and knobs

The buttons are used for Up, Down, Right, Left and
Confirm (middle button) during configuration and setting.
Welding stop (1). Stops all travel motions, all motors and welding current.
Welding start (2). The LED is lit when welding is in progress.
The OK button (5) is used to confirm a selected choice.
The Back button (6) is used to go back one step inte the menu.
Press Manual wire feed upwards button (7) to feed the wire upwards. The wire is
fed as long as the button is pressed.
Press Travel motion (8) button to drive in the direction of welding where the symbol
is indicated on the weld equipment.
Fast motion button (9) is used together with other buttons to increase speed. Press
the button to activate fast motion and then press manual wire feed (7, 10) or travel
motion (8, 11) button. The LED on the fast motion button is lit while fast motion is
activated. Press again to deactivate fast motion.
During configuration, it is possible to confirm and save a value and return to previous
screen using the Fast motion button.
Press Manual wire feed downwards button (10) to feed the wire downwards. The
wire is fed as long as the button is pressed.
Press Travel motion (11) button to drive in the direction of welding where the symbol
is indicated on the weld equipment.
Three different welding data memories per welding head can be stored in the control
panel memory using the soft keys 1, 2 and 3 (12). The soft keys have also varying
functions depending on which menu currently is in use. The current function can be
seen from the text in the bottom row of the display.
The welding current / wire feed speed/balance knob
decreasing set values.
The arc voltage / offset voltage knob
values.
0463 893 001
Left
(3) is used for increasing or
1
1 (4) is used for increasing or decreasing set
- 22 -
Up
Right
Down
© ESAB AB 2023