Adjustments; Welding Positions - ESAB Versotrac Cadet EWT 1000 Instruction Manual

5 OPERATION
Select the WELDING MENU
Select a menu row using the Up/Down buttons and press OK or confirm with the
middle button.
Set a numerical value using the Arc voltage / Offset voltage knob (4). Other
values are selected using the Up and Down buttons.
Press OK or the Middle button to confirm and return to the previous menu level.
The new value is displayed.
Return to previous menu level WITHOUT changed settings with Back or the Left
button.
5.8

Adjustments

1) Adjust the guide roller device distance, both in front and back of welding tractor.
2) Adjust the horizontal/cross seam slide, see scale next to the slide.
3) Adjust the rotation angle of the column.
4) Adjust the rotation angle of the welding head, see scale next to handle.
5) Adjust the wire pressure.
6) Vertical adjustment of the welding head, see scale next to the slide.
5.9

Welding positions

It is possible to adjust and change the angles of the weld head and other parts such as flux container
and pendant. Below there are tips on how to adjust the weld head angle.
Some things are important to make sure, to get the benefits of this tractor:
• The horizontal slide is meant to be cross seam at all times, so the weld head can be
adjusted easily before and during welding.
• The wire liner is located in a good position that makes the wire go in to the wire
straightener in the correct angle.
0463 893 001
by pressing the Right button.
- 26 - © ESAB AB 2023