Work Piece Voltage Reference Brush - ESAB Versotrac Cadet EWT 1000 Instruction Manual

5 OPERATION
1) Welding head position in front of the tractor: Welding head is in the middle position as it is
delivered.
2) Welding head position between 0 and 90°: Use the two adjustments on the top and underneath the
horizontal slide to put the weld head between 0-90°. Make sure that the horizontal slide is cross
seam and the wire liner is placed in a good position.
3) Welding head position on the side of the tractor: By turning the top adjustment on the horizontal
slide 90° and turn the adjustment underneath the horizontal slide 90°, the horizontal slide cross
seam and the wire liner will be in a good position, with the right angle in to the wire straightener.
5.10

Work piece voltage reference brush

The Versotrac offers an alternative work piece voltage reference through a mounted brush. The work
piece voltage reference brush provides a stable work piece voltage reference for the welding power
source. The solution effectively eliminates disturbance in the arc voltage measuring cables by
providing a more stable welding arc.
This is the recommended solution for work piece reference when welding with an AC power source
with Versotrac.
0463 893 001 - 27 - © ESAB AB 2023