Initial Configuration; Startup - ESAB Versotrac Cadet EWT 1000 Instruction Manual

5 OPERATION
The travel speed/frequency knob
values.
Only with Aristo® 1000 in AC mode.
1
5.7.2

Initial configuration

At first startup after delivery, after a program update and after a completed reset, the control panel
requires initial configuration. The initial configuration starts automatically.
Initial configuration can also be initiated by pressing and holding
logo is shown.
It is possible for an authorised user to change the configuration in the
1) Select language using the Up/Down/Right/Left buttons. Confirm with
2) Select measurement unit using the Right/Left buttons. Confirm with
3) Set date using the Up/Down buttons. Change between year, month and day with the Right/Left
buttons. Confirm with
4) Set time using the Up/Down buttons. Change between hours and minutes with the Right/Left
buttons. Confirm with
5) Select wire type using the Up/Down buttons. Confirm with
6) Select wire dimension using the Up/Down buttons. Confirm with
7) After initial configuration, the control panel continues to the
5.7.3

Startup

1) The software version is shown on the control panel during startup.
2) Previously selected wire type and wire dimension is shown. Press any button within 7 seconds to
open the menu. Select wire type and wire dimension using the buttons Up/Down and OK.
If no button is pressed, the control panel continues to the
or wire dimension.
0463 893 001
1
OK or with the middle button.
OK or with the middle button.
- 23 -
(13) is used for increasing or decreasing set
OK during startup, while the ESAB
GENERAL SETTINGS
OK
OK
OK or with the middle button.
OK or with the middle button.
SET menu.
SET menu with no changes on wire type
menu.
or with the middle button.
or with the middle button.
© ESAB AB 2023