Communication Error; Lost Contact With The Unit; No Gas Flow; High Welding Current - ESAB Versotrac Cadet EWT 1000 Instruction Manual

8 EVENT CODES

Communication error

14
The system's CAN bus has temporarily ceased to work due to excessive load.
The current welding process is stopped.
1. Check the equipment to ensure that only one wire feed unit or remote control unit is connected.
2. If the error is repeated, send for a service technician.

Lost contact with the unit

17
Lost contact with a unit.
1. Check wiring and the connector between the control unit and power source.

No gas flow

32
Start prevented.
1. Check the gas valve, hoses and connectors.

High welding current

43
Power source have switched off the welding process because the current has exceeded the maximum
current parameter for the power source.
1. Is reset at next weld start. If the error persists, send for a service technician.

Current servo saturation

44
The welding process has stopped because it has not advanced within 10 seconds.
1. Is reset at next weld start. If the error persists, send for a service technician.
High welding current
71
Power source have switched off the welding process because the current has exceeded the maximum
current parameter for the power source.
1. Is reset at next weld start. If the error persists, send for a service technician.

High inductance

88
Inductance is too high, depending on long welding cables and/or high weld data.
1. Adjust the welding data.

Internal communication error (warning)

93
The load on the system's CAN-bus is temporarily too high. The power source may have lost contact
with the control unit
1. Check that all the equipment is correctly connected. If the error persists, send for a service
technician.
0463 893 001 - 36 - © ESAB AB 2023