Operation; General - ESAB PEI Instruction Manual

GB
5

OPERATION

5.1

General

General safety regulations for the handling of the equipment can be found on
page 50. Read through before you start using the equipment!
1. Position the automatic welding head at the starting point of the weld joint.
2. Position the wire near the work piece by means of toggle switch S5.
3. Cut the wire at an angle.
4. Adjust the approximate, anticipated values of welding voltage, wire speed, and
tractor speed by means of the respective knob.
5. Select the start mode and the travel direction.
6. Start welding by pushing the knob S1.
7. Make fine adjustments of the welding parameters according to the read--outs
and the quality of the weld using the respective knob.
8. Press pushbutton S2 to stop welding.
9. If necessary adjust the value of burn--back time, see on page 56.
fgc6o1ea
- - 59 - -