L.B. White Journeyman Owner's Manual page 21

5. Loosen the mounting terminal strip bracket from the
burner housing.
6. Slide the terminal strip bracket off of the burner
chassis.
7. Remove the two inside screws holding the air
pressure to the terminal strip bracket.
8. To reinstall new switch, reverse the procedure.
Burner Fan Wheel Removal
1. Locate and remove three T20 torque screws on
burner housing.
Screws
2. Pull burner housing out to expose fan wheel.
3. Inspect fan wheel, clean, or replace if necessary.
4. If removal is require, use a 4mm allen key to loosen
fan wheel set screw and pull fan wheel out.
Journeyman Ductable Dual Fuel Indirect-Fired Heater
BRACKET
SCREW
Owner's Manual • Journeyman
Burner Motor Removal
1. Remove fan wheel, see Fan Wheel Removal
procedure.
2. Remove Air Pressure Switch, see Air Pressure
Switch removal procedure
3. Remove the primary control box from it's sub-base
by loosing the side screw.
4. Locate and remove the burner motor wires from the
terminal block.
5. Remove the two 5mm allen head screws holding the
motor to the burner housing.
6. Remove burner motor.
21