Model Name Gx8-B - Epson GX Series Manual

Industrial Robot: SCARA Robots GX series Manual

3.2.2 Model Name GX8-B

a: Arm length
45: 450 mm
55: 550 mm
65: 650 mm
b: Joint #3 stroke
2: 200 mm (GX8-B**2S*, E*), 170 mm (GX8-B**2C*, P*)
3: 330 mm (GX8-B**3S*, E*), 300 mm (GX8-B**3C*, P*)
c: Environmental specifications
S: Standard (equivalent to IP20)
E: ESD (anti-static)
C: Cleanroom & ESD (anti-static)
P: Protection class: IP 65
d: Mounting specifications
□: Table top mounting
W: Wall mounting
R: Ceiling mounting
e: Cable mounting direction
□: Standard (table top mounting - cable routing from rear side, wall mounting - cable routing from top side, ceiling
mounting- cable routing from rear side)
B: Cable routing from bottom side (table top mounting only)
Environmental specifications
ESD (anti-static) specifications: GX8-B***E*
ESD specifications are specifications that use conductive materials for or apply plating to the major resin parts as anti-static
measures.
We have confirmed that the Manipulator tip (tool mounting section) is at ±5 V or less, even directly after the measuring
operation according to Seiko Epson standards.
If you need any other detailed information, please contact the supplier.
Also, please check the amount of charge on any hand, wiring, or the like that you will attach to the robot on your own
before use.
Cleanroom & ESD (anti-static) specifications: GX8-B***C*
Manipulators with cleanroom & ESD (anti-static) specifications have a base design with the standard specifications, but as
an additional feature, have reduced dust emissions from the Manipulator to enable use in cleanroom environments.
Protected-model (IP65): GX8-B***P*
Manipulators with protected-models have a base design with the standard specifications, but as an additional feature, can
be used in adverse environments such as those exposed to oil smoke and dust.
These are compliant with the IP65 protection class (IEC 60529, JIS C0920).
For details on the specifications, refer to the following section.
Appendix A: Specifications Table
Rev.7
136