Installing The Detector (Overview) - Thermo Scientific VC-D60 Operating Manual

5 • Installation
5.1

Installing the Detector (Overview)

Page 44
A Thermo Fisher Scientific service engineer installs and sets up the
Vanquish system, including all modules and options or parts shipped
with them. The service engineer checks that the installation is correct
and that the Vanquish system and modules operate as specified. The
engineer also demonstrates the basic operation and main features.
If personnel other than a Thermo Fisher Scientific service engineer
installs the device, follow the steps below.
NOTICE
The device is part of the Vanquish system. Therefore, follow the order
for installing the system modules as described in the Vanquish System
Operating Manual.
The steps in the diagram are basic installation steps. Follow the in-depth
instructions of each step in the diagram in the given sequence.
See Safety Guidelines for Installation (} page 46)
See
See
See Loosening the Locking Screws (} page 53)
Connect the cables and power cords
See
See Setting Up the Flow Connections (} page 58)
See Setting Up the Device in the Software (} page 65)
See
Observe the safety guidelines
↓
Observe all site requirements
Site Requirements (} page 47)
↓
Set up the system stack
System Arrangement (} page 50)
↓
Loosen the locking screws
↓
Connecting the Device (} page 54)
↓
Set up the flow connections
↓
Set up the device in the software
↓
Turn on the device
Turning On the Device (} page 67)
↓
Refractive Index Detector (VC-D60)
Operating Manual