Thermo Scientific VC-D60 Operating Manual page 41

Refractive Index Detector (VC-D60)
Operating Manual
Figure 6: Carrying handles on the device
No. Component
1 Carrying handles
2 Attachment screw (one on each carrying handle)
4. Place the device on a stable surface.
5. If applicable:
Remove any additional packing material. Leave any protective films
attached to the surfaces of the device until it is properly positioned
in the system stack.
6. On each carrying handle, loosen the attachment screw until the
carrying handle is moveable in the rail. Do not remove the screws
from the carrying handles completely.
7. Slide off the carrying handles from the rails towards the rear of the
device.
Figure 7: Sliding off the carrying handle from the left rail
TIP Keep the shipping container, the carrying handles with the
attachment screws, and all packing material. These items will be needed
if the device is transported to a new location or shipped.
8. Some surfaces including the doors of the device are covered by a
protective film during shipment. Remove the protective film from all
surfaces as applicable.
4 • Unpacking
Page 41