PRODUCT DESCRIPTION
1.8.4 Volume Pre-Selection of Sound Signal
Proceed as illustrated, under point 1.8.1, to enter this program mode, press the key "accel/decel" (5).
In the display, "accel/decel" (A-2), flashes the word, "service". Select the letter, "U" with the
adjustable knob (1). As a result, appearing in the display, "rpm/rcf" (A-1), are the words, "Vol=0-
9/Sound". By pressing the key, "rpm/rcf" (4), the desired volume can be adjusted between 0 (low)
and 9 (loud), with the adjustable knob (1), (see Figure 6).
After the settings have been stored by user (see 1.8.1), the normal program mode can be changed
back again by switching off the centrifuge, for a short period.
Figure 6
1.8.5 Song Selection - End of Run
Proceed as illustrated, under point 1.8.1, to enter this program mode, press the key, "accel/decel"
(5). In the display, "accel/decel" (A-2) flashes the word, "service". Select the letter, "G" with the
adjustable knob (1). As a result, appearing in the display, "rpm/rcf" (A-1), the word " SonGo/Sound".
After pressing the key „rpm/rcf" (4), select a song with the adjusting knob (1), (see Figure 7).
After the settings have been stored by user (see 1.8.1), the normal program mode can be changed
back again by switching off the centrifuge, for a short period.
Figure 7
14
Z446K_V1.22_eng
9
8
1
7
© Hermle Labortechnik GmbH