To Reload User Data From A Sequencer - Rocktron Prophesy II User Manual

!
Do not allow a looping
connection from the MIDI
OUT/THRU of the receiving
Prophesy back to the MIDI
IN of the transmitting
sequencer when performing
a preset dump. Only use the
connections shown at right
when dumping data from one
Prophesy to another.
———————
When dumping data to and
from the Prophesy, always
perform the dump in real
time sequence mode. This
will ensure that data loaded
back into the Prophesy is not
sent faster than the Prophesy
can receive it.
———————
Also, make sure that the
sequencer's MIDI filter is
configured to accept SYSX
information.
90
———————————————————————————————————————————————————
1 Connect a standard MIDI cable from the MIDI OUT of the transmitting
sequencer to the MIDI IN of the receiving Prophesy, as shown below.
———————————————————————————————————————————————————
2 Play back the data stored on the sequencer. The Prophesy will auto-
matically begin storing the information as it is sent from the sequencer,
and will display the data strings as it is storing them. After all the data
has been loaded, the Prophesy will display "LOAD COMPLETE".
PRESET UTILITY
LOAD COMPLETE
———————————————————————————————————————————————————
PLAY