Dumping All Prophesy Presets Into A Sequencer - Rocktron Prophesy II User Manual

!
When dumping data to and
from the Prophesy, always
perform the dump in real
time sequence mode. This
will ensure that data loaded
back into the Prophesy is not
sent faster than the Prophesy
can receive it.
———————
When dumping data to and
from the Prophesy, always
perform the dump in real
time sequence mode. This
will ensure that data loaded
back into the Prophesy is not
sent faster than the Prophesy
can receive it.
———————
Also, make sure that the
sequencer's MIDI filter is
configured to accept SYSX
information.
88
———————————————————————————————————————————————————
1 Connect a standard MIDI cable from the MIDI OUT of the transmitting
Prophesy to the MIDI IN of the receiving sequencer, as shown below.
———————————————————————————————————————————————————
3 On the transmitting Prophesy, use the PAGE control to select the
PRESET UTILITY page.
PRESET UTILITY
PRESET DUMP
———————————————————————————————————————————————————
4 On the transmitting Prophesy, use the GAIN control to select the preset
utility entitled "DUMP ALL".
PRESET UTILITY
DUMP ALL