Rocktron Prophesy II User Manual page 6

6
————————————————————————————————————————————————
When pressed, switches all Prophesy effects out of the signal path. This
button is lit when the effects are bypassed.
————————————————————————————————————————————————
Fully attenuates the Prophesy outputs and activates the Prophesy built-in
tuner. This button lights when the Prophesy output is muted.
————————————————————————————————————————————————
Instantly accesses the Compressor page for the current preset. Once the
Compressor page has been displayed, this button can then be used to switch
the compressor in and out of the signal path. This button is lit when the
compressor is active.
————————————————————————————————————————————————
Instantly accesses the Wah page for the current preset. Once the Wah page
has been displayed, this button can then be used to switch the wah in and
out of the signal path. This button is lit when the wah is active.
————————————————————————————————————————————————
Instantly accesses the Phaser page for the current preset if it has been
assigned. When the Phaser page is displayed, this button can then be used
to switch the phaser in and out of the signal path. This button is lit when the
phaser effect is active.
————————————————————————————————————————————————
Instantly accesses the first Preamp page for the current preset. Once the
Preamp page is displayed, this button can then be used to switch the preamp
in and out of the signal path. When lit, the preamp is active. When not lit,
the preamp is bypassed and the signal only passes through any active
effects.
————————————————————————————————————————————————
Instantly accesses the Tremolo page for the current preset. When the
Tremolo page is displayed, this button can then be used to switch the
tremolo in and out of the signal path. This button is lit when the tremolo
effect is active.
————————————————————————————————————————————————
Switches the Loop in or out if it has been assigned.
————————————————————————————————————————————————
When pressed, looks to see if one of the three modulation effects is assigned
(flange, chorus or rotary). If the particular effect it is searching for is
assigned to the preset, the Prophesy displays the first page for that effect. If
not, displays a message indicating that the effect is not currently assigned.
Additional presses of the MODU button perform the same search for the
remaining two modulation effects.
————————————————————————————————————————————————
Instantly accesses the first Pitch Shift page for the current preset if it has
been assigned. When the first Pitch Shift page is displayed, this button can
then be used to switch the pitch shift effect in and out of the signal path. This
button is lit when the pitch shift effect is active.
————————————————————————————————————————————————
When viewing any page other than a delay or tremolo page, this button
allows you to tap the current delay time, tremolo rate, or both (depending on
the current setting of the TAPBTN parameter on the Tap button page).