Reverb Page 1; R-Pan; R-Dec; Hfdmp - Rocktron Prophesy II User Manual

Reverb Page 1:

5 0

R-PAN

122
L<29
R-PAN The REVERB PAN parameter allows you to pan the direct input signal to the
reverb section to the left or right—thus allowing for only the left or right channel
to be reverberated when used with the Dual reverb type, or, for one channel to be
reverberated to a greater degree than the other. It is adjustable from LEFT (0) to
RIGHT (100), where 1-49 appear between LEFT and CENTER, and 51-99
appear between CENTER and RIGHT.

R-DEC

The REVERB DECAY parameter specifies the length of time that the reverb
signal will sound before it has completely "died out". Note that the maximum
length of this decay will vary dependent upon the reverb type currently active. (0
to 99)

HFDMP

The HIGH FREQUENCY DAMPING parameter is used to control the decay
rate of high frequency information in the reverb signal. Higher parameter settings
will result in a faster decay of high frequency information. (0 to 99)
L-FRQ The LOW FREQUENCY parameter determines the amount of low frequency
information in the reverb signal. Higher levels of this parameter add more low
end. (0 to 99)
REV TYPE The REVERB TYPE parameter determines the active reverb type. The following
types are available: Plate A, Plate B, Room A, Room B, Hall A, Hall B, Stadium
and Dual.
R-DEC H F D M P L-FRQ
30 88 17
REVTYPE
HALL A