order for this function to operate properly, the Prophesy's MIDI receive channel must be
set to correspond to the MIDI channel that the other devices are transmitting MIDI
messages on. This section discusses how to set the MIDI receive channel.
82
The Prophesy can receive MIDI commands from other MIDI transmitting devices. In
———————————————————————————————————————————————————
1
Use the PAGE control to access the first MIDI page, which looks like
the page below.
———————————————————————————————————————————————————
2
Use the control labeled "GAIN" to select the MIDI channel on which
the Prophesy will receive MIDI commands from other devices.
Channels 1-16, OMNI (receive on all channels), or OFF (do not receive
MIDI commands) may be selected. Note that this number must match
the channel that the MIDI transmitter is sending MIDI commands on.
———————————————————————————————————————————————————
3
Use the control labeled "MID" to set the MIDI channel on which the
Prophesy will transmit controller information to a Rocktron All Access
footswitch. Note that this parameter only needs to be set when using
the Prophesy with an All Access, as the Prophesy does not transmit
MIDI program changes to any other devices.
MIDI RX
TX
REMOTE
TITLE
REMID
1
1
OFF
OFF
MIDI RX
TX
REMOTE
TITLE
REMID
OMNI
1
OFF
OFF
MIDI RX
TX
REMOTE
TITLE
OMNI
4
OFF
OFF
0
0
REMID
0