Midi Pages; Midi Page 1: Midi Channels - Rocktron Prophesy II User Manual

MIDI send and receive channels and configure MIDI program changes.

MIDI Page 1: MIDI Channels

6 2
The MIDI pages provide numerous MIDI setup options. These pages allow you to set
MIDI RX
122
1
MIDI RX This parameter sets the MIDI channel that the Prophesy will receive MIDI
commands on. In order for the Prophesy to receive MIDI commands, this
parameter must be set to the same channel that the MIDI transmitting device
is transmitting commands to the Prophesy on. "OMNI" may also selected,
which allows the Prophesy to receive commands on all MIDI channels. (1-
16, OMNI)
MIDI TX This parameter sets the MIDI channel that the Prophesy will transmit
controller information to a Rocktron All Access footswitch. Note that this
parameter only needs to be set when using the Prophesy with an All Access,
as the Prophesy does not transmit MIDI program changes to other devices.
(1-16, OMNI)
REMOTE When switched "ON", the REMOTE parameter configures the Prophesy to
be controlled from a Rocktron All Access footpedal operating in Remote
mode. (Off, On)
TITLE When switched "ON", the TITLE parameter enables preset title transfers
from the Prophesy to the All Access display. Note that only the first 13
characters of the title can be displayed by the All Access. (Off, On)
REM ID The REM ID (Remote ID) parameter must be matched with the Remote Title
Number parameter from the All Access' Setup pages to transmit preset titles
from the Prophesy to the All Access.
T X R E M O T E TITLE REM ID
1 O N O N 12