Mixer Page 4: Post Effect 3 Mix Levels; Pst3-In Mix; Efx 3 Out - Rocktron Prophesy II User Manual

Mixer Page 4: Post Effect 3 Mix Levels

122

PST3-IN MIX

EFX 3 OUT

EFFECT USED
The PST2-IN MIX and PST3-IN MIX parameters act as a balance between the direct and effect that
is entering the assigned effect of Post effect blocks 2 and 3. For example, lets say that DUCKER/
DELAY is assigned to Post 1 effect block and that CHORUS is assigned to Post 2 effect block.
Adjusting the PST2-IN MIX parameter to 100% DIRECT would cause only the direct guitar tone to
be chorused while the delayed signal would not be chorused. Adjusting the PST2-IN MIX
parameter to 100% EFFECT would cause only the delayed signal to be chorused while the direct
guitar tone would not be chorused. Adjusting the PST2-IN MIX parameter anywhere between
DIRECT and EFFECT would cause a blend of the direct and the delayed signal to be chorused.
The REV IN (Reverb in) parameter on the following page works the same way.
(PST3-IN MIX) (EFX 3 OUT)
DIRECT OFF
The PST3-IN MIX parameter determines how much of the signal applied to
the Post Effect 3 effect is direct signal, and how much is effect signal. (100%
Direct to 100% Effect)
The EFX 3 OUTPUT parameter determines the output level of the effect
that is assigned to Post Effect 3. (Off, -42.0 to +6.0)
The EFFECT USED parameter displays the name of the effect that is
currently assigned to the Post Effect 3 location. (Not adjustable)
(EFFECT USED)
EMPTY
5 5