Chorus Pages 1 And 2: Voices 1 And 2 - Rocktron Prophesy II User Manual

(referred to here as Voices 1-4), detuning these delayed signals (slightly changing their
pitch), then modulating the detune effect so that the amount of pitch detune is constantly
varying. Using different detune amounts, modulation rates, modulation depths and pan
settings for each delayed signal will produce a greater perceived spaciousness.

Chorus Pages 1 and 2: Voices 1 and 2

DEPTH1 and 2
3 8
The Chorus effect in the Prophesy is produced by using up to four delayed signals
C H O R U S
122
O N
CHORUS The CHORUS parameter determines whether the Chorus is active or bypassed
for the current preset. (This parameter is displayed only on Page 1.) (Off, On)
LVL1 and 2 The LEVEL parameter determine the volume of Voice 1 relative to the other
voices. (Off, -42.0 to +6.0)
PAN1 and 2 The PAN parameter allows for Voice 1 to be panned to the left or right channel.
(Left to Right)
DLY1 and 2 The DELAY parameter allows you to select the minimum delay time (in
milliseconds) for Voice 1. This delayed signal is detuned and modulated to
produce the chorus effect. Shorter delay times will result in a tighter sounding
chorused signal, while longer delay times will produce a larger ambient effect. (0
to 100)
The DEPTH parameter adjusts the amount of modulation of Voice 1. A lower
depth setting will produce a more subtle detune effect, while a higher setting
results in a more extreme detuning. (0 to 58)
RATE1 and 2 The RATE parameter determines the sweep speed (or the speed at which each
voice is modulated). Lower parameter settings result in slower speeds, while
higher settings result in faster speeds. (0 to 253)
LVL1 PAN1 DLY1 DEPTH1
- 2.0 L<26 68 50
RATE1
125