Advertisement
Resume / Freeze: Stops the video capture from the fiberscope. If the optional Auto Freeze feature is
l
enabled, the test set will automatically freeze the image when it comes into focus. Once the image is
frozen, tap the image to save it.
Analysis On / OFF: Turn ON/OFF the automatic Pass/Fail threshold defined by IEC 61300-3-35.
l
Auto Freeze: Turn ON/OFF the ability to freeze the video automatically, when in Focus. The default
l
is set to OFF. To see the image after it freezes, tap Resume.
Auto Freeze may be useful when scoping certain angled polish fibers.
Rectangles / Dots: Dots draw a red contour around scratches and defects. Rectangles highlight
l
scratches and defects without obstructing the view. The selection between dots or rectangles does
not affect the area calculation or the Pass/Fail results. Dots are set as default.
Shake: Turn ON or OFF Auto Freeze/Analysis prevention when probe image is unsteady, such as
l
when inspecting a female connector or bulkhead. It minimizes significant vibrations and unstead-
iness generated from the fiberscope being held. Typically, this function is not always needed with
the use of image focusing.
When inspecting bulkhead couplers or MUX/transceivers set Shake to OFF.
MPO mode: Turn ON when inspecting ribbon fibers (MPO/MPT connectors). Create a New Group
l
for each MPO ribbon and Capture Fiber to save an image for each strand.
When inspecting MPO/MPT connectors, it is recommended to set Auto Freeze and Shake to OFF.
To save the image on the screen, tap the screen after freezing.
After saving, go to Results or > Utilities > FilesFiles to view the report and export to PDF or USB.
85
© VeEX Inc. All Rights Reserved.
Platform Functions
Advertisement
