Advertisement
To simplify the configuration for this example, one test set is configured as a Client and the other as a
Server. In reality however, as mentioned previously, both tests will be running simultaneously.
1. Select Bi-Directional from the V-Perf Mode drop-down menu on both test sets. Select the Bi-Dir-
ectional Mode as Client on the Local End and Server on the Remote end.
2. Press Start test at the Near End. The entire test flow is automated. Results will show up as the tests
run – a total of 4 sessions.
Current test progress is shown in Event.
l
Summary (Page 1) provides information on the current session running and the RFC-6349
l
key performance indicators. Tap on Client Results to verify the metrics.
Final results of the completed test will show under Status.
l
V-TEST
The V-TEST feature qualifies network TCP/HTTP protocol performance by testing Internet speeds up to a full
line rate against a server to verify the maximum download and upload data rates attainable by subscribers'
high-speed or Gigabit Internet services.
53
Local End Tester - Bi-Directional Server Setup
© VeEX Inc. All Rights Reserved.
Ethernet
Advertisement
