Advertisement
MPO MM female: User when inspecting MM ribbon cables with MPO/MTP connector via
l
coupler.
3. After the image is frozen, select the Auto center/Crop checkbox to crop and center the IEC rings on
display. This is recommended when inspecting Angled bulkheads/couplers with Shake OFF.
4. Select the Capture tab.
Capture Images (View)
The Capture tab is the main user interface for the connector end face inspection and analysis. It presents a
real-time view of the connector's end face allowing for alignment and focus. Page 1 of the capture screen dis-
plays a live image of the connector face and features analysis and freeze tools.
The fiber end face image will normally display near the middle of viewing window area. The exception will be
when inspecting bulkhead/couplers of APC connectors or using A6 type tips. The end face image will appear
off-center. AutoFocus and Shake OFF setting is recommended when inspecting couplers. Gently adjust cen-
tering while manually focusing the image and image will freeze as soon as focus is achieved.
For the DI-3000, press the autofocus (red target) button when the image is out of focus to enable the device's
automated focusing operation. With a steady hand, the end face will be promptly autofocused and ready for
capture.
Initially, there is no screen shown until Resume is pressed.
The radio buttons on the right panel do not indicate the current state or setting, they indicate the action that
would take place if pressed. For example, if "Analysis OFF" is tapped, the analysis function is turned OFF and
the button displays "Analysis ON".
Platform Functions
Fiber Scope Capture - Dots vs Rectangles
© VeEX Inc. All Rights Reserved.
84
Advertisement
