Advertisement
Basic V-TEST
When the MTX150x Lite is powered on the test set automatically loads the V-TEST (VeEX Internet Speed
Test) application using nearby Ookla servers as the default.
Run a Speed Test
Press and hold the Power button
logo appears on the screen, then release the power button.
The test set will take a few seconds to boot up, automatically start the V-TEST (VeEX Internet Speed Test)
application, detect the link, auto-configure and get an IP address. The Basic V-Test defaults to use Ookla's
speedtest.net servers for the speed test.
Once ready, the Basic V-TEST screen displays with a GO button
set is ready to test.
To turn the test set OFF, press and hold the Power button
heard.
By default, the test set always starts in BASE-T copper mode
tion button. It can detect 10GBASE-T, 5GBASE-T, 2.5GBASE-T, 1000BASE-T and even legacy 10/100BASE-
T automatically.
Changing Test Modes (Copper ↔ Fiber)
By default, the test set starts in copper (RJ45) mode and it can detect 10GBASE-T, 5GBASE-T, 2.5GBASE-T,
1000BASE-T and even legacy 10/100BASE-T automatically.
Changing Test Modes
To change between fiber optics and copper test modes:
1. Tap
, then tap Test Mode button at the bottom left of the screen to access the Layer4 Test
Mode Selection menu.
2. For Fiber Optics, tap
priate test mode: 1GE (1000M BASE-X) or 10GE or 1000M/2.5G/5G/10G BASE-T.
3. Press OK and wait for the test application to load.
Ethernet
for two seconds, until a confirmation tone (beep) is heard, and the VeEX
and for Copper, tap
© VeEX Inc. All Rights Reserved.
in the center. This indicates that the test
until two confirmation tones (beeps) are
, as indicated by the Test Mode Selec-
, then select the checkbox for the appro-
54
Advertisement
