Select the operation mode and the interfaces that will be used to carry out tests. Once the operating mode and
interfaces are selected, independently configure the auto-negotiation, speed, duplex, and flow control settings
for each port (where applicable).
After configuring settings, tap Apply to save changes. Tap Discard to revert to previous selections.
100/1000Base-X and 100/1000Base-T Port
Auto Negotiation: On or Off. Matches the test set's negotiation settings to those of the link partner
l
Speed (only when Auto Negotiation is Off for 100/1000T): 10 Mbps, 100 Mbps, or 1000 Mbps
l
Duplex (only when Auto Negotiation is Off): Half or Full
l
Advertisement (only when Auto Negotiation is On for 100/1000 Base-T): Default-All or Custom.
l
Custom options include 10/100/1000M/Half or 10/100/1000M/Full.
Flow Control: TX On, RX On, Both On, or Off
l
When flow control is On, the test set will respond to pause frames received by the link partner
l
by adjusting the transmit rate
When flow control is Off, the test set ignores all incoming pause frames from the link partner
l
and continues transmitting at the configured transmit rate
Clock Offset (1000 Mbps only): The frequency may be offset in parts per million
l
29
100/1000Base-X Port Setup
© VeEX Inc. All Rights Reserved.
Ethernet