Advertisement
Power ON/OFF: Press and hold the red Power button (B) for about two seconds, until the test set emits one
beep, to turn it ON. To turn the test set OFF, press and hold the Power button (B) for about two seconds until
the test set beeps twice, then wait for the power LED (D) to turn OFF. It is suggested to wait for at least 10
seconds before turning the test set back ON.
Forced Power OFF: In the unlikely event that the test set becomes irresponsive or behaves improperly, user
can press and hold the Power button (B) for about six seconds to force the test set off. No results will be saved.
Standby Mode: First, release any active test application and then press and hold the Home button (C) for
about three seconds to activate the Sleep or Standby mode. Once activated, the power LED (D) will flash
green, to indicate that the test set is in standby mode (the fans may stay on for a while, until all electronics cool
down). This mode is used to conserve battery when the test set is required to "boot up" and be ready to test
faster.
While in Standby mode, users can quickly press the Home button to have a glance of the current standby time
and remaining battery charge.
To bring the test set back to full operation, press the Home button (C) again for about three seconds.
Save Results: Press the blue Save button (A) on the front to SAVE current test results.
Home Menu: Press the green Home button (C) on the front to go back to the Main Menu. Tap on the red Exit
(X) icon, on the screen, to go back to the previous menu level.
Screen Capture: By pressing the Save and right slider buttons (A+F) simultaneously, users can store a pic-
ture of the current screen (screenshot) in the File Manager. The test set will emit a confirmation beep/tone
when the screen is captured. The images are named with a date + time code. Go to the File Manager to man-
age, view or transfer captured screens (>Utilities >Files >Saved).
Touch Screen Calibration: In the rare event that the touch screen may become irresponsive, press the Save
+ Home buttons (A+C) simultaneously to invoke the touch screen calibration procedure. Refer to the
"Touch
Screen Calibration" on page 128
section for more details.
Clean Software Install: With the test set OFF, press Save + Power buttons (A+B) simultaneously to initiate a
clean software install from an USB memory stick. Refer to the
"Software Update Process" on page 131
section
for more details.
All settings, test results and user data will be erased. Performing a backup to a USB memory stick is
recommended (>Utilities >File >Saved, select all and tap on the To USB button).
Software Update: With the test set OFF, press Power + Home buttons (B+C) simultaneously to initiate a soft-
ware update from an USB memory stick. Refer to the Software Update Process section for more details. Set-
tings, test results and user data will be preserved.
Touch-Screen Display
The LCD supports touch-screen operation. To operate the touch-screen, use the stylus located in the top cover
to navigate the menus and tabs. Please observe the following precautions:
21
© VeEX Inc. All Rights Reserved.
Basic Operation
Advertisement
