Advertisement
MDIX (100/1000Base-T only): Off, On, or Auto. When MDIX is set to Auto, the test set detects the
l
required cable connection type and configures the port connection properly for interfacing the part-
ner device, eliminating the need for crossover cables.
Transmit clock offset (100/1000Base-T only): Disabled or Enabled. Due to hardware limitation,
l
transmit clock offset is only valid when PHY is working on Master mode. Clock offset measurement
is only valid when PHY is working on Slave mode.
PHY working mode: Master or Slave.
l
Transmit Ignore Link Status: On/Off
l
Synchronous Ethernet (SyncE): Disabled or Enabled. When Enabled, makes the signal traceable
l
to an internal or external reference clock.
For information on configuring SyncE operation, see Port Page 2 - Mode Selection in the
SyncE
section.
Status
The Status tab lists current port settings. Please note that the Status tab is only available if a fiber port option is
selected from the Test Port Selection menu.
Ethernet
Status tab for 10/100/1000Base-T
© VeEX Inc. All Rights Reserved.
30
Advertisement
