Table of Contents
Advertisement
8 RIDING INSTRUCTIONS
8.7
8.8
8.9
28
Quickshifter
Activating the quickshifter
Shifting, riding
Warning
Danger of accidents If you change down at high engine speed, the rear wheel blocks and the engine races.
–
Do not change into a low gear at high engine speed.
Info
If unusual noises occur while riding, stop immediately, switch off the engine, and contact an authorized
GASGAS Motorcycles workshop.
First-gear is used for starting off and for steep inclines.
When the quickshifter is activated, you can shift up without actuating
the clutch.
Info
The quickshifter is not activated when shifting up from first to
second gear, and the clutch lever must be used when shifting up
instead.
Even if the quickshifter is activated, you need to use the clutch
lever to shift down.
Because there is no need to close the throttle grip, uninterrupted gear
shifts are possible.
The quickshifter uses the shifter shaft position to check whether or not a
shift should be initiated, and sends a corresponding signal to the engine
control.
If the quickshifter is deactivated, the clutch needs to be actuated in the
normal way for each shift.
F03643-10
–
Press the QS button
The QS indicator lamp lights up when the quickshifter is acti-
vated.
Info
The quickshifter is not activated when shifting up from first
to second gear, and the clutch lever must be used when
shifting up instead.
Even if the quickshifter is activated, you need to use the
clutch lever to shift down.
F03760-12
–
Shift into a higher gear when conditions allow (incline, road situa-
tion, etc.). To do so, release the throttle while simultaneously pulling
the clutch lever, shift into the next gear, release the clutch lever and
open the throttle.
–
If the cold start button was pushed while starting, open the throttle
briefly and release the throttle grip or turn the throttle grip forward.
1
to switch the quickshifter on or off.
Advertisement
Table of Contents
