Table of Contents
Advertisement
6.14
Foot brake lever
6.15
Plug-in stand
6.16
Factory Start
1
Foot brake lever
The foot brake lever is used to activate the rear brake.
401956-10
The support for plug-in stand
The plug-in stand is used to park the motorcycle.
The plug-in stand is used as a fork locker when transporting the motor-
cycle.
Info
Remove the plug-in stand before riding.
The tool can be attached to the plug-in stand holders.
H02629-10
1
The Factory Start
Possible states
•
A
Factory Start is deactivated – The fork is in the normal operat-
ing mode.
•
B
Factory Start is activated – The fork is compressed and the
front of the motorcycle is lowered.
Activating the Factory Start lowers the front of the motorcycle, which
then causes the front wheel to lift off the ground when accelerating.
When the fork compresses for the first time, the Factory Start lock but-
ton is released automatically. From this point on, the fork operates as if
the Factory Start were deactivated or not installed.
H04998-10
is located in front of the right footrest.
1
is the left side of the wheel spindle.
is mounted on the right fork protector.
CONTROLS 6
19
Advertisement
Table of Contents
