GAS GAS MC 250F FACTORY EDITION 2023 Owner's Manual page 77

–
Check the chain sliding guard for wear.
» If the lower edge of the chain pins is in line with, or below, the
chain sliding guard:
–
Change the chain sliding guard.
–
Check that the chain sliding guard is firmly seated.
» If the chain sliding guard is loose:
–
Tighten screws on the chain sliding guard.
Guideline
Screw, chain sliding
guard on link fork
W00221-10
–
Check the chain sliding piece for wear.
» If the lower edge of the chain pins is in line with or below the
chain sliding piece:
–
Change the chain sliding piece.
–
Check that the chain sliding piece is firmly seated.
» If the chain sliding piece is loose:
–
Tighten screw on the chain sliding piece.
Guideline
Screw, chain sliding
piece
F03714-10
–
Check the chain guide with a slide gage for dimension
Minimum thickness
chain guide
» If the measured value is less than the specified value:
–
Change the chain guide.
F03687-10
SERVICE WORK ON THE CHASSIS 11
M6
M8
6 mm (0.24 in)
C
of the
6 Nm (4.4 lbf ft)
15 Nm (11.1 lbf ft)
C
.
75