GAS GAS MC 250F FACTORY EDITION 2023 Owner's Manual page 93

–
Manually press the brake caliper toward the brake disc to push back
the brake piston. Ensure that brake fluid does not flow out of the
brake fluid reservoir; extract some if necessary.
Info
Make sure that you do not press the brake caliper against
the spokes when pushing back the brake piston.
–
Remove cotter pins
ings.
W00192-10
–
Clean the brake caliper and the brake caliper bracket.
–
Check that spring plate
6
ing plate in the brake caliper bracket are seated correctly.
Info
The arrow on the spring plate points in the direction of rota-
tion of the brake disc.
W00193-10
–
Insert the new brake linings, insert pin
3
pins .
Info
Always change the brake linings in pairs.
Make sure that decoupling plate
ton side brake lining.
–
Operate the foot brake lever repeatedly until the brake linings are in
contact with the brake disc and there is a pressure point.
W00194-10
–
Correct brake fluid level to marking
Brake fluid DOT 4 / DOT 5.1 (
–
Mount and tighten screw cap
ring.
Info
Use water to immediately clean up any brake fluid that has
overflowed or spilled.
W00190-10
Finishing work
–
Install the frame protector. (
3 4
, pull out pin , and remove the brake lin-
5
in the brake caliper and brake pad slid-
4
, and mount cotter
7
is mounted on the pis-
A
.
p. 135)
1 2
with membrane
p. 50)
BRAKE SYSTEM 12
and the O-
91